All lessons

Lesson 5 of 5 · 10 min · Patterns in data

Light and shadow

Take readings over a minute and explain why the light level sometimes drops to zero.

Pick your level

Steps for beginner crews

  1. Make a table with two columns, time and light.
  2. Ask for a reading every 10 seconds for one minute.
  3. Circle the rows where light is 0 lx.

Check your work

Your table has at least six rows, and you circled the zeros.

Talk it over

Where could a satellite go that would make its light sensor read zero?

Steps for intermediate crews

  1. Record time, light (lx) and temperature (°C) every 5 seconds for one minute.
  2. Find how long the light stays on and how long it stays off.
  3. Plot light against time on paper or in a spreadsheet.

Check your work

You measured the on and off durations and drew the pattern.

Talk it over

The simulated cycle is 30 s. A real low-orbit pass around Earth takes about 90 minutes. What changes?

Steps for professional crews

  1. Sample once per second for 40 s and record sequence, light and temperature.
  2. Derive the light rule from the sequence numbers and confirm it against Sample::synthetic in the station source. In this demo the sequence is the time in seconds, like the station's simulate command; the installed classroom station counts requests instead.
  3. Describe how you would replace the synthetic eclipse with one computed from an orbit model.

Check your work

You stated the rule (lit when sequence mod 30 is below 20) and verified it against the data.

Talk it over

What inputs would an eclipse model need, and where would you get them for a real satellite?

Back to all lessons

Something unclear or wrong? Suggest a change on GitHub.

Connected to the practice CubeSat

  1. YouGround
  2. CubeSat
  3. SensorsPayload
Temperature
--
BatteryBus voltage
--
Light
--

No reading yet.

Raw telemetry (last reply)
No sample yet.

Tip: pause contact while pictures are coming in, then see what made it.

0 of 8 frames

Mission log

  1. Station ready.
Get help with this lesson

Lesson questions

Choose a question about light and shadow. Answers are prewritten.

Select a question to read the answer.

Continue with the bench labs

Install the local station and pick a hardware quest for Arduino, Seeed XIAO, Raspberry Pi, or a computer-only setup.

Local station and hardware quests

Choose a quest based on the hardware available to your class.

Open the quest board

Classroom support proposal

Review the proposal for hosted classroom tools and tell us what your school would need.

Read the proposal and give feedback