Flight preparation

A classroom experiment on a research spaceflight

What would a small sensor kit record on a suborbital research flight? This page helps a class predict it.

An independent volunteer project. Flight details come from public sources. The flight host decides what flies and when.

The ride, minute by minute

About 70 minutes from take-off to landing. Most of it is a slow climb. The part in space lasts a few minutes, so the kit has to be recording before it starts.

Inside the cabin the air stays at about the pressure of a mountain town. A pressure sensor there will not show the near-vacuum outside.

Make your own prediction
Height during the simulated research flightA slow climb to 13.6 kilometres over 50 minutes, a steep rise to 87.5 kilometres, then a fall and a glide to landing at 70 minutes.0204060801000102030405060Minutes after take-offHeight, km87.5 km, floatingRelease, 13.6 km
Desk simulation from public figures. Not flight data and not a flight plan.
  1. T+0:00
    Climb under the carrier aircraft

    Up to 13.6 km. About 1 g.

  2. T+50:00
    Release and rocket boost

    60 seconds. About 2.6 g in this model.

  3. T+51:00
    Microgravity

    About 193 seconds of floating. Highest point 87.5 km.

  4. T+54:13
    Re-entry

    The ship slows in thicker air. No g-load figure is published.

  5. T+57:13
    Glide and landing

    Runway landing about 70 minutes after take-off.

What the kit measures

A small printed CubeSat with an Arduino, a rechargeable battery and a clock that time-stamps every reading.

  • Temperature
  • Pressure
  • Acceleration
  • Rotation
  • Magnetic field
  • Carbon dioxide
  • Humidity
  • Light

Three rides, one set of sensors

Each ride teaches something different about the same measurements.

Perlan 2 glider

An engineless glider that rides mountain waves over the Andes. Student CubeSat experiments have flown in its science bay.

Height:
Up to 23 km (76,124 ft record)
Air on the sensor:
Open science bay: sensors sit in outside air
Weightlessness:
None
Open the Perlan 2 quest

Research spaceship

Carried to about 13.6 km by an aircraft, then a one-minute rocket burn.

Height:
About 87 km
Air on the sensor:
Pressurised cabin: pressure stays nearly flat
Weightlessness:
About 3 minutes
Predict the spaceflight

International Space Station

Circles Earth about every 90 minutes. CubeSats ride up as cargo and are released into their own orbit.

Height:
About 400 km
Air on the sensor:
Pressurised station; CubeSats are released outside
Weightlessness:
Continuous
Find the ISS
Compare all three in one quest

Seven steps to flight-ready

Each step ends with something a reviewer can check. Following the public guide does not earn a place on the flight; the host decides.

  1. 01
    Predict

    Run the flight model and write down what each sensor should record.

  2. 02
    Bench

    Log for the full length of a flight on a desk, with a deliberate gap.

  3. 03
    Compare

    Explain the same sensors on a glider, a spaceship and the ISS.

  4. 04
    Package

    Draft the payload paperwork and list every open question.

  5. 05
    Host review

    Get written answers from the flight host.

  6. 06
    Rehearse

    Time the switch-on, logging, switch-off and data hand-back.

  7. 07
    Fly and share

    Publish the measurements next to the predictions.